FENDER MXA2 BUNDLE
- HP2 Features:
- Level and Pan controls
- Sturdy belt clip
- 5/8” microphone stand mount socket
- Stereo 1/8" headphone connector
- Balanced 1/4" inputs
- FXA-2 Features:
- Custom 9.25mm precision rare-earth drivers with Groove-tuned™ port
- Universal fit wears like a custom monitor, providing cushion-like comfort
- 6Hz-23kHz frequency response for lifelike sound reproduction
- 112dB @1mW sensitivity for distortion-free audio
CUSTOM RARE-EARTH DYNAMIC DRIVERS
These dynamic drivers have a clear, sweet sound due to their full-range frequency response. Constructed with rare-earth magnets, which are more powerful than traditional magnet materials, these custom drivers are sure to please fans of rich, punchy low end.
Reproducing bass frequencies properly requires more air movement than needed for other frequencies. The Groove-tuned bass port on this model allows for more air to reach the driver, enhancing the bass response without adding size or weight to the monitors.
3D-PRINTED DIGITAL HYBRID TECHNOLOGY HOUSING
The 3D-printed housing provides a custom-molded-like fit derived from scanning thousands of ear canals and then compiling the results to create an "ideal" fit that works for 95% of users. This low-profile housing uses 3D printing for a precise fit that seals the ear canal to enhance bass while reducing ambient interference.
With the combination of the low-profile slimline shell and patent-pending secure-fit tips, these in-ear monitors reduce ambient noise by up to 18dB, allowing you to filter out unnecessary noise.
The HP2 headphone amplifier provides a simple way to drive musician's IEMs. It sports two XLR line level inputs and one stereo 1/8" (3.5mm) headphone output with volume control. Operation can be switched between stereo and mono, and a pan knob lets you dial in your mix.
PORTABLE AND COMPACT DESIGN
Designed for musicians, the lightweight, compact HP2 can be clipped to a belt or mounted on a mic stand, and operates for up to seven hours on a single 9V battery.
InputsTwo- Balanced 1/4” TRS Inputs
Headphone Jack1/8" Stereo
Other FeaturesOperates from 9V battery or DC 9V (Pin -, Ring +) adaptor (included), Sturdy belt clip, Maximum Operating Current: 40 mA, Nominal Input Level: 0 dBV, Maximum Input Level: +4 dBV, Limit Input Level: +5 dBm, Minimum Headphone Impedance: 16 Ohms per side.
Included AccessoriesStereo Input Cable, Power Supply, 3/8” to 5/8” Microphone Stand Adaptor, Deluxe Carrying Case, Secure-fitting Tips, Cleaning Tool and Cable
Input Impedance16 ohm +/- 10% @ 1kHz
Cable EndsDetachable MMCX Cable